"This kit was tailored made for the installer so that they have one tool kit that can do all the jobs of installation". The FiberFin hand tool can terminate the fiber, strip the jacket to the proper length and crimp tool can install the connector with consistent results every time which is a must for the professional installer. The termination process is very unique it is done by clamping the POF cable into place and then squeezing it and then a very precise round razor blade can cut the cable with a scissor like action without damaging the fiber. Damage to the fiber is a very common occurrence when you try to just cut POF with a normal razor blade, The exit cut will chip the fiber and cladding and the cut will not be as precise and perpendicular as with the FiberFin termination system that has a average attenuation loss 1.0 –1.5 db. The special blade on the FiberFin "all In One Tool" is mounted on a gear assembly that rotates the blade every time you cut a fiber so that you get even wear on the cutting blade and very constant fiber termination results. After approximately 1260 cuts the cutting assembly will stop and prevent the usage of the unit, at this time you are able to put on the replacement cutting head that is supplied with the kit and you’re ready to go again. FiberFin's cutting system is a safe way to handle termination of POF as the cutting system is enclosed and user friendly.
This means with this kit you get 2,500 quality terminations and the just order a new replacement head and start again!
Note: Attenuation is the limiting factor as regards to link length, so connectors in High speed data cabling need to have a very good attenuation characteristic. This requires the best possible termination techniques and processes this is found in the FiberFin Termination tools |
